Description
CERIAN 36W 24V LED Driver – IP20 Constant Voltage Power Supply
The CERIAN 36W 24V DC constant-voltage LED driver supplies compatible 24V LED strip lighting and other suitable low-voltage LED products. Model CE.DR24-36 is a non-dimmable power supply designed for stable output in appropriately installed lighting systems.
Technical Specifications
- Brand: CERIAN
- Model: CE.DR24-36
- Rated output power: 36W maximum
- Output: 24V DC constant voltage
- Rated output current: approximately 1.50A
- Input: 220–240V AC, 50/60Hz
- Ingress protection: IP20
- Dimming: Non-dimmable
- Dimensions: 133 × 42 × 30mm
- Protection: Short-circuit protection as stated in the existing product specification
- Lead: Existing product information describes a 1200mm flex with Australian two-pin plug; confirm supplied configuration before installation
How to Choose the Correct LED Driver
Check that your LED strip requires 24V DC constant voltage, then multiply its rated power per metre by the installed length. For example, 4 metres of 10W/m LED strip has a nominal load of 40W. Choose a driver with sufficient spare capacity for the application, considering manufacturer guidance, installation temperature, cable losses and any controller load. The connected load must not exceed the driver’s rated output.
This 36W model provides a rated maximum of 1.50A at 24V DC. For RGB or dimmable strips, use a compatible controller or approved control system between the driver and the lighting where required; the driver itself is non-dimmable.
Installation and Environmental Protection
Indoor use: The IP20 enclosure is intended for protected, dry indoor locations. Do not expose the driver to rain, splashes or condensation.
Allow appropriate ventilation and heat management, follow the manufacturer’s mounting instructions, and check electrical compatibility and required safety approvals. Have mains wiring and fixed electrical installation work performed by a licensed electrician.
Related LED Lighting Products
Browse the LED driver range, LED strip lights and LED controllers. Match voltage, wattage, current and environmental protection before ordering.
CERIAN 24V 36W LED Driver – FAQs
Which LED strips are compatible?
Choose 24V DC constant-voltage LED strips whose combined load is within the driver’s rated output. Check the full product specifications before installation.
How much LED strip can this power?
Divide the usable wattage by the strip’s watts per metre, leaving appropriate capacity for operating conditions. For example, 3 metres of 10W/m strip uses 30W before allowing for installation factors.
Is this driver dimmable?
Confirm dimming support in the product specifications; do not assume every 24V driver supports mains dimming.
Explore CERIAN LED strip lights and other LED drivers.
